[Gristmillers] Table Top Mill

[Mark Greer]

Looks a lot like a CS Bell No. 60. See link below. The No. 60 is the one on the right and was normally sold to be used as an electric motor powered mill. They are still available today and judging by the condition of the one in your pictures it is a recent model. I have a CS Bell No. 2 that I use to make chicken feed.
http://www.csbellco.com/grinding-grist-mills.asp
Mark Greer
  ----- Original Message ----- 
  From: marcus walker 
  To: gristmillers at gristmillers.com 
  Sent: Friday, November 07, 2008 11:51 PM
  Subject: [Gristmillers] Table Top Mill


              Can someone help me identify this mill ?  It is 17 1/2" high, The grain hopper is 4 3/4"x5 1/4" square..  It has the # 2MB on the base, # 66 or A66 on the exit chute, # A60 on the main body and # A 62 on the front hub behind the adjustment locking arm. It has a serial # stamped behind the belt pulley but I can' make it out without removing the pulley. It has a auger in the bottom of the grain hopper,  and appears to have metal plates. Any help would be appreciated.  Pictures are at   http://www.flickr.com/photos/29260386@N02/

              Thanks Marcus. 
       




------------------------------------------------------------------------------


  _______________________________________________
  Gristmillers mailing list
  Gristmillers at gristmillers.com
  http://lists.gristmillers.com/mailman/listinfo/gristmillers
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.gristmillers.com/pipermail/gristmillers/attachments/20081108/8d75ea71/attachment.html